Prosthetic Body Hits - Bullet Holes - Glue On

These Bullet Hole Prosthetic pieces are a latex edged wound that was sculpted to simulate actual gun shot wounds.

Three body hits per package.

Apply with Spirit Gum or Liquid Latex. I have included links for these below.

Super Easy Application Instructions:
Brush on Spirit Gum to the back of any area where the Body Hits is touching the skin. Spirit Gum may also be applied directly to the skin, especially on larger pieces. Hold the appliance against the skin to determine proper placement. Although most of the appliances can be worn in several places, it is best to check for proper alignment of some pieces. Edges may be trimmed for a better fit. Position the Body Hits onto your skin in the desired area and press into place. For best adhesion, remove the Body Hits and use the piece itself or your index finger to tack the Spirit Gum with a rapid up and down motion. This will cause the Spirit Gum to become extremely tacky. Then Firmly press the piece back into place.

Using a cotton swab or brush, apply Blood Gel to any area you desire to have a thick gooey look. For a more realistic look you can add stage blood, to give you a freshly bleeding look.

Suggestions for a more Professional Look:
For thinner edges, after applying the Body Hits to your skin with Spirit Gum, the edges of the Body Hits may be stippled, using a small piece of White Latex Sponge with a thin coat of Flesh Latex. Allow this to dry before applying a second coat. A hair dryer set on low will help speed up the drying time. Powder the dried latex when finished.